Wind Noise at the A-Pillar

April 23, 1996

BULLETIN NO
96-014

YEAR
1996

MODEL
SLX

VIN APPLICATION
ALL

Wind Noise at the A-Pillar

SYMPTOM

A vibration or buzzing noise coming from the area of the A-pillar at speeds over 60 mph.

PROBABLE CAUSE

The rubber molding along the edge of the windshield is vibrating.

REQUIRED MATERIALS

3M Super Silicone Sealant: 3M P/N 051135-08662

CORRECTIVE ACTION

Seal the rubber molding to the A-pillar with adhesive.





1. To protect the paint, apply a strip of masking tape (minimum of 1 inch wide) to the A-pillar along the edge of the rubber molding.





2. Using an 0-ring pick or similar tool, pull the rubber molding away from the A-pillar. Apply 3M Super Silicone Sealant (see REQUIRED MATERIALS) under the rubber molding along the full length of the A-pillar.

3. Press the rubber molding against the A-pillar with your fingers to smooth it out and make sure it sits flush.

4. Allow the sealant to set for about 5 minutes. Remove the masking tape and clean up any excess adhesive with 3M General Purpose Adhesive Cleaner.

5. Repeat steps 1 thru 4 on the other A-pillar.

WARRANTY CLAIM INFORMATION

In warranty:
The normal warranty applies.

Out of warranty:
Any repair performed after warranty expiration may be eligible for goodwill consideration by the District Technical Manager or your Zone Office. You must request consideration, and get a decision, before starting work.

Operation number: 824701

Flat rate time: 0.4 hour

Failed P/N: 8-94358-797-6

Defect code: 056

Contention code: B07