Front

REMOVAL
1. Raise the vehicle and support the frame with suitable safety stands.
2. Remove the stone guard.
3. Remove wheel and tire assembly.
4. Remove nut and washer.

CAUTION: Be careful not to break the ball joint boot.

5. Remove link.
6. Remove bracket.
7. Remove stabilizer bar.
8. Remove rubber bushing.

INSPECTION AND REPAIR
Make necessary correction or parts replacement if wear, damage, corrosion or any other abnormal conditions are found through inspection. Check the following parts:
- Stabilizer bar
- Rubber bushing
- Link ball joint

INSTALLATION
1. Install rubber bushing.
2. Install stabilizer bar.
3. Install bracket, then tighten it to the specified torque.

Torque: 22 Nm (16 ft. lbs.)

4. Install link.
5. Install nut and washer, then tighten the nut to the specified torque.

Torque: 50 Nm (37 ft. lbs.)