With Tech 2 Scan Tool

TECH 2 SCAN TOOL





From 98 MY, Isuzu dealer service departments are recommended to use Tech 2. Please refer to Tech 2 scan tool user guide.

GETTING STARTED
- Before operating the Isuzu PCMCIA card with the Tech 2, the following steps must be performed:

1. The Isuzu 98 System PCMCIA card (1) inserts into the Tech 2 (5).
2. Connect the SAE 16/19 adapter (3) to the DLC cable (4).
3. Connect the DLC cable to the Tech 2 (5)
4. Mark sure the vehicle ignition is off.
5. Connect the Tech 2 SAE 16/19 adapter to the vehicle ALDL/DLC connector.





6. The vehicle ignition turns on.
7. Verify the Tech 2 power up display.





NOTE: The RS232 Loop back connector is only to use for diagnosis of Tech 2 and refer to user guide of the Tech 2.

OPERATING PROCEDURE








The power up screen is displayed when you power up the tester with the Isuzu systems PCMCIA card. Follow the operating procedure below.