Rear Door Window Glass: Service and Repair

Rear Door Glass, Quarter Glass and Regulator Replacement

NOTE: Put on gloves to protect your hands.

1. Remove these items:
- Door panel
- Plastic cover




2. Carefully move the glass (A) until you can see the bolts, then remove them. Carefully lower the glass. Take care not to drop the glass inside the door.




3. Remove the bolt (A) and collar (B) from the rear channel (C). Pull the upper seal (D) away as needed, and remove the screw (E). Pull the glass run channel (F) away as needed from the rear channel.
4. Move rear channel away from the quarter glass (G), then remove it out through the window slot. Take care not to damage the door molding (H).




5. Carefully remove the glass (A) out through the window slot. Take care not to drop the glass inside the door.
6. Remove the door glass outer weatherstrip.




7. Remove the quarter glass (A).




8. Disconnect and detach the connector (A) and harness clip (B) from the door. Remove the bolts (C), and loosen the bolts (D), then remove the regulator (E) through the hole in the door.




9. Grease all the sliding surfaces of the regulator (A) where shown.
10. Install the door glass, quarter glass, and regulator in the reverse order of removal, and note these items:
- Roll the glass up and down to see if it moves freely without binding.
- Make sure that there is no clearance between the glass and glass run channel when the glass is closed.
- Adjust the position of the glass as necessary.