Locks: Service and Repair
Trunk Pass-through Cover Key Cylinder ReplacementNOTE:
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
- Take care not to scratch the cover.
1. Using a flat-tip screwdriver, pry the rear seat handle (A) up at either hook portion (B) on forward side of the trunk pass through cover (C). Then slide the handle half-way up.
2. From trunk compartment side of the cover, using a small screwdriver, press the inside hook (A) down through the access hole (B).
3. While pressing the hook, pry the trunk handle (C) up with a flat-tip screwdriver.
4. Remove the trunk handle (A) and rear seat handle (B) together at the same time.
5. Remove the retainer clip (C), then remove the trunk pass-through cover key cylinder (D) from the cover (E).
6. Install the key cylinder in the reverse order of removal, and note these items:
- Put the two handles together before installing them on the trunk pass-through cover.
- Make sure the trunk pass-through cover opens properly and locks securely.