Instrument Panel

Instrument Panel Removal/Installation

NOTE:
- When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
- Take care not to scratch the dashboard and related parts.

1. Tilt the steering column down.




2. Remove the instrument panel (A):
1. Remove the screws (B).
2. Gently pull out the panel to release the clips (C and D).
3. Disconnect the dash lights brightness controller connector (E), select/reset switch connector (F), and VTM-4 lock switch connector (G).

3. Install the instrument panel in the reverse order or removal, and make sure each connector is plugged in properly.