Interior - Beverage Holder Won't Stay Open
02-023September 9, 2002
Applies To:
2001-02 MDX - ALL
Beverage Holder Will Not Open
SYMPTOM
The beverage holder lid will not open.
PROBABLE CAUSE
The beverage holder spring is missing.
CORRECTIVE ACTION
Install a new beverage holder spring.
PARTS INFORMATION
Beverage holder spring: P/N 77231-S3V-A00
WARRANTY CLAIM INFORMATION
In warranty:
The normal warranty applies.
Operation Number: 044105
Flat Rate Time: 0.2 hour
Failed Part: P/N 77230-S3V-A01ZA
Defect Code: 078
Contention Code: B99
Template ID: 02-023A
Skill Level: Repair Technician
Out of warranty:
Any repair performed after warranty expiration may be eligible for goodwill consideration by the District Parts and Service Manager or your Zone Office. You must request consideration, and get a decision, before starting work.
REPAIR PROCEDURE
1. Apply a 3-inch piece of tape to the edge of the beverage holder lid. Leave about an inch unattached to use as a handle.
2. Push down on the front edge of the beverage holder, and lift the lid by the tape.
3. Remove the beverage holder by lifting it straight up.
4. Install a new spring, reinstall the beverage holder, and test operation by opening and closing the lid several times.
Disclaimer