Cover Tapered Roller Bearing Outer Race Removal/Installation

Removal/Installation

Special Tools Required
- Driver 07749-0010000
- Attachment, 72 x 75 mm 07746-0010600

NOTE: Replace the bearing with a new one whenever the outer race is replaced.





1. Remove the bearing outer race (A) and 75 mm thrust shim (B) from the transfer cover (C). If the bearing outer race is press-fitted, remove the bearing outer race by heating the cover to about 212°F (100°C) with a heat gun (D). Do not heat the cover more than 212°F (100°C).
2. Install the 75 mm thrust shim (A) in the transfer cover (B).





3. Install the bearing outer race (C) in the cover. If the outer race is press-fitted, use the special tools.