P2135

DTC P2135: Throttle Position Sensor 1/2 Incorrect Voltage Correlation

1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Wait 10 seconds.
4. Check for Temporary DTCs or DTCs with the HDS.

Are any Temporary DTCs or DTCs indicated?

YES - If DTC P2135 is indicated, go to step 7. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC troubleshooting.

NO - Go to step 5.

5. Do the ETCS TEST in the INSPECTION MENU with the HDS.
6. Check for Temporary DTCs or DTCs with the HDS.

Are any Temporary DTCs or DTCs indicated?

YES - If DTC P2135 is indicated, go to step 7. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC troubleshooting.

NO - Intermittent failure, system is OK at this time. Check for poor connections or loose terminals at the throttle actual or control module and the PCM.

7. Turn the ignition switch OFF.
8. Replace the throttle body.
9. Turn the ignition switch ON (II).
10. Reset the PCM with the HDS.
11. Do the PCM idle learn procedure.
12. Check for Temporary DTCs or DTCs with the HDS.

Are any Temporary DTCs or DTCs indicated?

YES - If DTC P2135 is indicated, check for poor connections or loose terminals at the throttle actuator control module and the PCM, then go to step 1. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC troubleshooting.

NO - Troubleshooting is complete.