P2176

DTC P2176: Throttle Actuator Control System Idle Position Not Learned

NOTE: If DTC P2135 is stored at the same time as DTC P2176, troubleshoot DTC P2135 first, then recheck for DTC P2176.

1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Turn the ignition switch OFF.
4. Turn the ignition switch ON (II) and wait 10 seconds.
5. Check for Temporary DTCs or DTCs with the HDS.

Is DTC P2176 indicated?

YES - Go to step 6.

NO - Intermittent failure, system is OK at this time. Check for poor connections or loose terminals at the throttle actuator control module and PCM, then clean the throttle body.

6. Turn the ignition switch OFF.
7. Disconnect the intake air duct from the throttle body.
8. Turn the ignition switch ON (II).
9. Clear the DTC with the HDS.
10. Do the ETCS TEST in the INSPECTION MENU with the HDS.
11. Watch the throttle valve movement.

NOTE: Be careful not to pinch a finger during work.

Does the throttle valve operate to its full closed position?

YES - Go to step 12.

NO - Substitute a known-good throttle actuator control module, then go to step 16 and recheck. If DTC P2176 is not indicated, replace the original throttle body, then go to step 16.

12. Check for sludge or carbon on the throttle valve.

Is there sludge or carbon on the throttle valve?

YES - Clean the throttle body, then go to step 17 and recheck.

NO - Go to step 13.

13. Turn the ignition switch OFF.
14. Replace the throttle body.
15. Turn the ignition switch ON (II).
16. Reset the PCM with the HDS.
17. Do the PCM idle learn procedure.
18. Turn the ignition switch OFF.
19. Turn the ignition switch ON (II) and wait 10 seconds.
20. Check for Temporary DTCs or DTCs with the HDS.

Are any Temporary DTCs or DTCs indicated?

YES - If DTC P2176 is indicated, check for poor connections or loose terminals at the throttle actuator control module and at PCM, then do the throttle body cleaning, then go to step 1. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC's troubleshooting.

NO - Troubleshooting is complete.