P2422

DTC P2422: EVAP Canister Vent Shut Valve Close Malfunction

1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Open the fuel fill cap for 5 seconds, then tighten it.
4. Start the engine. Hold the engine speed at 3,000 rpm with no load (in Park or neutral) until the radiator fan comes on, then let it idle.
5. Monitor the OBD STATUS for DTC P2422 in the DTCs MENU with the HDS.

Does the screen indicate FAILED?

YES - Go to step 6.

NO - If the screen indicates PASSED, intermittent failure, system is OK at this time. If the screen indicates NOT COMPLETED, go to step 2 and recheck.

6. Clear the DTC with the HDS.
7. Remove the EVAP canister vent shut valve.
8. Connect the 2P connector to the EVAP canister vent shut valve.
9. Turn the ignition switch ON (II).
10. Do the EVAP CVS ON in the INSPECTION MENU with the HDS.




11. Check the EVAP canister vent shut valve (A) operation.

Is the valve operating?

YES - Check for blockage in the EVAP canister, then go to step 14.

NO - Go to step 12.

12. Turn the ignition switch OFF.
13. Replace the EVAP canister vent shut valve.
14. Turn the ignition switch ON (II).
15. Reset the PCM with the HDS.
16. Do the PCM idle learn procedure.
17. Turn the ignition switch OFF.
18. Remove the fuel fill cap for 5 seconds, then tighten it.
19. Start the engine. Hold the engine speed at 3,000 rpm with no load (in Park or neutral) until the radiator fan comes on, then let it idle.
20. Check for Temporary DTCs or DTCs with the HDS.

Are any Temporary DTCs or DTCs indicated?

YES - If DTC P2422 is indicated, check for poor connections or loose terminals at the FTP sensor, the EVAP canister vent shut valve, and the PCM, then go to step 1. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTC troubleshooting.

NO - Go to step 21.

21. Monitor the OBD STATUS for DTC P2422 in the DTCs MENU with the HDS.

Does the screen indicate PASSED?

YES - Troubleshooting is complete.

NO - If the screen indicates FAILED, check for poor connections or loose terminals at the FTP sensor, the EVAP canister vent shut valve, and the PCM, then go to step 1. If the screen indicates NOT COMPLETED, go to step 16 and recheck.