Displaying & Reading Trouble Codes

Displaying the Diagnostic Trouble Code (DTC)

1. Turn the ignition switch OFF, and move the seat to a non-memorized position.




2. Press and hold the MEMO button (A) and both position buttons (B) at the same time.
3. Turn the ignition switch ON (II), and wait at least 1 second, then release the three buttons.
4. After 1 second, the position button indicators (C) will blink to show the DTC.




DTC Indications

No System Problem Pattern
If there is no DTC stored, the indicators blink only once (3 seconds).




System Problem Pattern
If a system problem occurs and a DTC is stored, the indicators will show the DTC. The-first digit is indicated by the number of long (1 second) blinks, and the second digit is indicated by the number of short (0.26 second) blinks. There is a 3 second break between each DTC when there are multiple DTCs.

Canceling the DTC Indication

- Turn the ignition switch OFF or
- Press the MEMO button, or position button 1, or position button 2, or
- Press one of the driving position adjustment switches.

Erasing the DTC from Memory
Make sure you have the anti-theft code for the radio and the navigation system, then write down the frequencies for the radio's preset button. Disconnect the battery negative cable for at least 30 seconds. After reconnecting the battery, enter the anti-theft codes for the radio and the navigation system, then enter the customer's radio station presets. Reset the clock. Perform the power-train control module (PCM) idle learn procedure and the power window control unit reset procedure.