Seals and Gaskets: Service and Repair

PULLEY END CRANKSHAFT SEAL INSTALLATION - IN CAR

Installation - In Car

Special Tools Required
Oil seal driver 64 070AD-RCA0100

1. Dry the crankshaft oil seal housing.
2. Apply a light coat of grease to the crankshaft and to the lip of the seal.





3. Using the seal driver, drive in the crankshaft oil seal until the driver bottoms against the oil pump. When the seal is in place, clean any excess grease off the crankshaft, and check that the oil seal lip is not distorted.