Operation CHARM: Car repair manuals for everyone.
Home >> Acura Truck >> 2004 >> MDX V6-3471cc 3.5L >> Repair and Diagnosis >> Relays and Modules >> Relays and Modules - Restraints and Safety Systems >> Air Bag Control Module >> Service and Repair >> SRS Unit Replacement

SRS Unit Replacement

SRS Unit Replacement

Removal
1. Disconnect the battery negative cable, and wait at least 3 minutes before beginning work.
2. Disconnect both seat belt tensioner connectors.
3. Remove the center console side trim.




4. Pull down the carpet, then remove the Torx bolt (A) from the SRS unit.




5. Disconnect the connectors and remove the two Torx bolts (A), then pull out the SRS unit.

Installation




1. Install the new SRS unit (A) with Torx bolts (B), then connect the connectors to the SRS unit; push it into position until it clicks.

NOTE: Be sure the SRS unit is sitting squarely against its bracket before torquing the Torx bolts.

2. Install the center console side trim.
3. Reconnect both seat belt tensioner connectors.
4. Reconnect the battery negative cable.
5. Initialize the OPDS unit.
6. After installing the SRS unit, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off.
pro multis · About Operation CHARM