Control Unit Input Test
Power Window Control Unit Input Test1. Remove the driver's door panel.
2. Disconnect the 18P connector (A) from the power window control unit (B).
3. Inspect the connector and socket terminals to be sure they are all making good contact.
- If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.
- If the terminals look OK, go to step 4.
4. With the connector still disconnected, make these input tests at the connectors.
- If any test indicates a problem, find and correct, then recheck the system.
- If all the input tests prove OK, go to step 5.
5. Reconnect the 18P connector to the power window control unit and reconnect the passenger's multiplex control unit, then make these input tests at the connector.
- If any test indicates a problem, find and correct the cause, then recheck the system.
- If all the input tests prove OK, the control unit must be faulty; replace it.