Disconnecting System Connectors

Disconnecting System Connectors




Turn the ignition switch OFF, and disconnect the negative cable from the battery, and wait at east 3 minutes before beginning the following procedures.
- Before disconnecting the cable reel 4P connector (1), disconnect the driver's airbag 4P connector (2).
- Before disconnecting SRS unit connector B (3) from the SRS unit, disconnect both seat belt tensioner 2P connectors (4,5).

1. Turn the ignition switch OFF. Disconnect the battery negative cable, and wait at least 3 minutes.

Driver's Airbag




2. Remove the access panel from the steering wheel, then disconnect the driver's airbag 4P connector (A) from the cable reel 4P connector (B).

Front Passenger's Airbag




3. Remove the glove box, then disconnect the front passenger's airbag 4P connector (A) from the SRS main harness 4P connector (B).

Side Airbag




4. Disconnect the side airbag 2P connector (A) from the SRS side subharness 2P connector (B).

Seat Curtain Airbag




5. Disconnect the side curtain airbag 2P connector (A) from the roof wire harness.

Seat Belt Tensioner




6. Remove the B-pillar lower trim panel. Disconnect the seat belt tensioner 2P connector (A) from the SRS side subharness 2P connector (B).

SRS Unit




7. Remove the center console side trim. Disconnect SRS unit connector A, SRS unit connector B, or SRS unit connector C from the SRS unit.