Programming and Relearning

Resetting the Power Window Control Unit

Resetting the power window control unit is required after performing the following procedures
- Disconnecting the battery.
- Removing the No.8 (20A) fuse from the under-hood subfuse box.
- Disconnecting the 18P connector from the power window control unit.
- Removing the window regulator, glass or glass run channel.
- Disconnecting the driver's door wire harness.

1. Turn the ignition switch OFF.
2. Turn the ignition ON (II).
3. Lower the driver's window all the way down by pushing the driver's switch to the second detent (AUTO DOWN) when the window reaches the bottom, hold the driver's window switch in the AUTO DOWN position for 2 seconds.
4. Raise the driver's window all the way up without stopping by pulling the driver's switch to the second detent (AUTO UP) when the window reaches the top, hold the driver's window switch in the AUTO UP position for 2 seconds.
If the window does not work in AUTO, reset the power window control unit according to the above procedure again.