DTC Troubleshooting
DTC P0340: CMP Sensor A No SignalNOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Start the engine.
4. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0340 indicated?
YES - Go to step 5.
NO - Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at CMP sensor A and the PCM.
5. Turn the ignition switch OFF.
6. Disconnect the CMP sensor A 3P connector.
7. Turn the ignition switch ON (II).
8. Measure voltage between CMP sensor A 3P connector terminal No. 3 and body ground.
Is there battery voltage?
YES - Go to step 9.
NO - Repair open in the wire between CMP sensor A and the No. 3 IG1 ACG (15 A) fuse, then go to step 18.
9. Measure voltage between CMP sensor A 3P connector terminal No. 1 and body ground.
Is there about 5 V?
YES - Go to step 10.
NO - Go to step 11.
10. Measure voltage between CMP sensor A 3P connector terminals No. 2 and No. 3.
Is there battery voltage?
YES - Go to step 16.
NO - Repair open in the wire between CMP sensor A and G101, then go to step 18.
11. Turn the ignition switch OFF.
12. Jump the SCS line with the HDS.
13. Disconnect PCM connector C (44P).
14. Check for continuity between PCM connector terminal C41 and body ground.
Is there continuity?
YES - Repair short in the wire between the PCM (C41) and CMP sensor A, then go to step 18.
NO - Go to step 15.
15. Check for continuity between CMP sensor A 3P connector terminal No. 1 and PCM connector terminal C41.
Is there continuity?
YES - Go to step 23.
NO - Repair open in the wire between the PCM (C41) and CMP sensor A, then go to step 18.
16. Turn the ignition switch OFF.
17. Replace CMP sensor A.
18. Reconnect all connectors.
19. Turn the ignition switch ON (II).
20. Reset the PCM with the HDS.
21. Do the PCM idle learn procedure.
22. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0340 indicated?
YES - Check for poor connections or loose terminals at CMP sensor A and the PCM, then go to step 1.
NO - Troubleshooting is complete. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTCs troubleshooting
23. Reconnect all connectors.
24. Update the PCM if it does not have the latest software, or substitute a known-good PCM.
25. Check for Temporary DTCs or DTCs with the HDS.
Is DTC P0340 indicated?
YES - Check for poor connections or loose terminals at CMP sensor A and the PCM. If the PCM was updated, substitute a known-good PCM, then recheck. If the PCM was substituted, go to step 1.
NO - If the PCM was updated, troubleshooting is complete. If the PCM was substituted, replace the original PCM. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTCs troubleshooting.