DTC Troubleshooting

DTC P0735: Problem in 5th Clutch and 5th Clutch Hydraulic Circuit

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information.

1. Warm up the engine to normal operating temperature (the radiator fan comes on).
2. Make sure that the transmission is filled to the proper level, and check for fluid leaks.
3. Drain the ATF through a strainer. Inspect the strainer for metal debris or excessive clutch material.

Does the strainer have metal debris or excessive clutch material?

YES - Replace the transmission, then go to step 9.

NO - Replace the ATF, then go to step 4.

4. Measure the line pressure.

Is the line pressure within the service limits?

YES - Go to step 5.

NO - Repair the ATF pump and the regulator valve, or replace the transmission, then go to step 9.

5. Measure the 5th clutch pressure.

Is the 5th clutch pressure within the service limits?

YES - Go to step 6.

NO - Shift valves A, B, C, and D are stuck. Repair these valves and the hydraulic circuit, or replace the transmission, then go to step 9.

6. Clear the DTC with the HDS.
7. Test-drive the vehicle for several minutes under the same conditions as those indicated by the freeze data, or drive in 5th gear in the sequential sportshift mode in the S position at speeds over 10 mph (16 km/h) for 20 seconds. Slow down and stop the wheels.
8. Monitor the OBD status for P0735 in the DTCs/Freeze Data in A/T Mode Menu for a pass/fail.

Does the result indicate FAILED?

YES - Repair the 5th clutch, or replace the transmission, then go to step 9.
NO - Intermittent failure, the system is OK at this time. If the HDS indicates NOT COMPLETED, return to step 7 and recheck.

9. Clear the DTC with the HDS.
10. Test-drive the vehicle for several minutes under the same conditions as those indicated by the freeze data, or drive in 5th gear in the sequential sportshift mode in the S position at speeds over 10 mph (16 km/h) for 20 seconds. Slow down and stop the wheels.
11. Monitor the OBD status for P0735 in the DTCs/Freeze Data in A/T Mode Menu for a pass/fail.

Does the result indicate PASSED?

YES - Troubleshooting is complete.

NO - If the HDS indicates FAILED, return to step 1 and recheck. If the HDS indicates NOT COMPLETED, return to step 10 and recheck.