DTC Troubleshooting

DTC P1297: ELD Circuit Low Voltage

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information.

1. Turn the ignition switch ON (II).
2. Check the ELD in the DATA LIST with the HDS.

Is 72 A or more indicated?

YES - Go to step 3.

NO - Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the ELD and the PCM.

3. Turn the ignition switch OFF.
4. Disconnect the ELD 3P connector.
5. Turn the ignition switch ON (II).
6. Check the ELD in the DATA LIST with the HDS.

Is 72 A or more indicated?

YES - Go to step 7.

NO - Go to step 11.

7. Turn the ignition switch OFF.
8. Jump the SCS line with the HDS.
9. Disconnect PCM connector A (44P).




10. Check for continuity between PCM connector terminal A23 and body ground.

Is there continuity?

YES - Repair short in the wire between the PCM (A23) and the ELD, then go to step 13.

NO - Go to step 20.

11. Turn the ignition switch OFF.
12. Replace the ELD.
13. Reconnect all connectors.
14. Turn the ignition switch ON (II).
15. Reset the PCM with the HDS.
16. Do the PCM idle learn procedure.
17. Start the engine, and let it idle.
18. Turn on the headlights.
19. Check for Temporary DTCs or DTCs with the HDS.

Is DTC P1297 indicated?

YES - Check for poor connections or loose terminals at the ELD and the PCM, then go to step 1.

NO - Troubleshooting is complete. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTCs troubleshooting.

20. Reconnect all connectors.
21. Update the PCM if it does not have the latest software, or substitute a known-good PCM.
22. Start the engine, and let it idle.
23. Turn on the headlights.
24. Check for Temporary DTCs or DTCs with the HDS.

Is DTC P1297 indicated?

YES - Check for poor connections or loose terminals at the ELD and the PCM. If the PCM was updated, substitute a known-good PCM, then go to step 22. If the PCM was substituted, go to step 1.

NO - If the PCM was updated, troubleshooting is complete. If the PCM was substituted, replace the original PCM. If any other Temporary DTCs or DTCs are indicated, go to the indicated DTCs troubleshooting.