Operation CHARM: Car repair manuals for everyone.
Home >> Acura Truck >> 2007 >> RDX L4-2.3L Turbo >> Repair and Diagnosis >> Accessories and Optional Equipment >> Navigation System >> Testing and Inspection >> Reading and Clearing Diagnostic Trouble Codes >> Description of On-Board Diagnostics >> System Diagnostic Mode >> Start-Up Procedure and Diagnostic Menu

Start-Up Procedure and Diagnostic Menu

Start-up procedure and Diagnostic Menu

There are two ways to enter the diagnostic mode:

1. Connect the SCS service connector to the navigation service connector located behind the navigation unit. Then turn the ignition switch ON (II). The display will go directly to the diagnostic menu screen shown below.

NOTE: When finished troubleshooting, make sure to remove the SCS service connector.

2. Turn the ignition switch ON (II). Use the navigation display hard buttons as described below:




Make sure the battery is connected then press and hold the three buttons (Menu, Map/Guide, and Cancel), and keep them pressed for approximately 5 seconds. The display screen will go directly to the "Select Diagnosis Items" in the menu.

3. After the display changes to the Select Diagnosis Items menu, select the item you want to check and the diagnostic will start. To return to the previous screen, select "RETURN".
- Navi System (Link)
- Monitor Check
- Unit Check
- Car status
- F-CAN (System link)
- GPS information
- Yaw Rate
- Tire Calibrate
- Functional Setup
- Version
- XM (HIP)
pro multis · About Operation CHARM