Multi-Information Switch Test/Replacement
Multi-information Switch Test/Replacement1. Remove the driver's airbag assembly.
2. Disconnect the 7P connector (A) from the multi-information switch (B).
3. Remove the steering wheel cover (C) from the steering wheel.
4. Remove the multi-information switch from the steering wheel by removing the four screws.
5. Measure resistance between the multi-information switch 7P connector No. 2 and No. 6 terminals in each switch position according to the table.
6. If the resistance is not as specified, then replace the switch.
7. If the switch is OK, but there is a problem with the switch function, check the cable reel subharness and cable reel.