Disconnecting System Connectors

Disconnecting System Connectors




Turn the ignition switch OFF disconnect the negative cable from the battery, and wait at least 3 minutes before beginning the following procedures.

- Before disconnecting the cable reel 4P connector (1), disconnect the driver's airbag 4P connector (2).
- Before disconnecting SRS unit connector B from SRS unit, disconnect both seat belt tensioner 4P connectors and both seat belt buckle tensioner 4P connectors (3, 4, 5, 6).

1. Disconnect the negative cable from the battery, and wait at least 3 minutes.

Driver's Airbag




2. Remove the access panel (A) from the steering wheel, then disconnect the driver's airbag 4P connector (B) from the cable reel.

Front Passenger's Airbag
3. Remove the glove box.
4. Remove the dashboard upper panel.




5. Disconnect the dashboard wire harness 4P connector (A) from the front passenger's airbag.

Side Airbag




6. Disconnect the side airbag 2P connectors (A) from the SRS wire harness.
7. Remove the headliner.




8. Disconnect both SRS wire harness 2P connectors (A) from the side curtain airbags.

Seat Belt Tensioner

9. Remove the front and rear door sill trim.




10. Remove the B-pillar lower trim, then disconnect both SRS wire harness 4P connectors (A) from the seat belt tensioners.

Seat Belt Buckle Tensioner




11. Disconnect both SRS wire harness 4P connectors (A) from the seat belt buckle tensioner.

SRS Unit




12. Disconnect both seat belt tensioner connectors and both seat belt buckle tensioner connectors.
13. Remove the center console.
14. Disconnect SRS unit connector A (28P), SRS unit connector B (28P) and SRS unit connector C (16P) from the SRS unit.