Operation CHARM: Car repair manuals for everyone.

Audio System - Buzz From Rear Satellite Speakers

07-024

May 30, 2007

Applies To:
2007 RDX - From VIN 5J8TB185.7A000001 thru 5J8TB185.7A009780

Buzz From Rear Satellite Speakers

SYMPTOM

The rear satellite speakers buzz when the audio is playing, or when the vehicle is driven over bumps.

PROBABLE CAUSE

The satellite speaker trim ring vibrates against the speaker grille.

CORRECTIVE ACTION

Apply wool felt to the rear satellite speaker trim ring.

REQUIRED MATERIALS

Wool Felt (enough to repair about 20 vehicles):
P/N 06993-5A5-000

TOOL INFORMATION

Diagnostic CD: T/N 07AAZ-SDB100

WARRANTY CLAIM INFORMATION

In warranty:
The normal warranty applies.

Operation Number: 0130A1

Flat Rate Time: 0.3 hour

Failed Part: P/N 84131-STK-A01ZA

Defect Code: 06201

Symptom Code: 04201

Template ID: 07-024A

Skill Level: Repair Technician

Out of warranty:
Any repair performed after warranty expiration may be eligible for goodwill consideration by the District Parts and Service Manager or your Zone Office. You must request consideration, and get a decision, before starting work.

DIAGNOSIS

Play the diagnostic CD to recreate the noise complaint. When you hear the buzz, apply pressure with your hand to the silver trim ring around the rear satellite speaker.

^ If the noise goes away, go to REPAIR PROCEDURE.

^ If the noise does not go away, disregard this service bulletin and continue with your normal diagnosis.

REPAIR PROCEDURE





1. Pry out the trim ring from the quarter pillar trim with a small flat blade screwdriver.

NOTE:
Use a shop towel to protect the trim.

2. Cut three 3 mm x 20 mm strips of the wool felt.





3. Apply the wool felt to the back side of the trim ring. Position the wool felt 1 mm from the outer edge of the trim ring so it is not visible after the trim ring is installed.

4. Reinstall the trim ring.

NOTE:
If you need to order a new trim ring, it is not available as a separate part. The trim ring comes with the quarter pillar trim.

5. Repeat steps 1 thru 4 for the other satellite speaker.

6. Make sure the noise is gone by playing the diagnostic CD.





Disclaimer