Driver's and Front Passenger's Power Window Motor Test
Driver's and Front Passenger's Power Window Motor Test1. Remove the door panel.
2. Disconnect the 6P connector from the power window motor.
Motor Test
3. Test the motor in each direction by connecting battery power and ground according to the table. When the motor stops running, disconnect one lead immediately.
4. If the motor does not run or fails to run smoothly, replace it.
Pulser Test
5. Reconnect the 6P connector to the power window motor.
6. Turn the ignition switch ON (II).
7. Check for voltage between the terminals.
- There should be battery voltage between the No. 5 (+) and No. 2 (-) terminals.
- Connect an analog voltmeter between the No. 6 (+) and No. 2 (-) terminals, and run the power window motor down or up. The voltmeter needle should move back and forth alternately (a digital voltmeter reads about 2.5 V).
- Connect an analog voltmeter between the No. 3 (+) and No. 2 (-) terminals, and run the power window motor down or up. The voltmeter needle should move back and forth alternately (a digital voltmeter reads about 2.5 V).
8. If the voltage is not as specified, do the power window switch input test:
- Driver's terminals No. 5, 6,7, and 11.
- Front passenger's terminals No. 2, 4, 5 and 6.
9. If the switch is OK, replace the power window motor.
10. Reset the power window control unit.