Operation CHARM: Car repair manuals for everyone.
Home >> Acura Truck >> 2008 >> RDX L4-2.3L Turbo >> Repair and Diagnosis >> Restraints and Safety Systems >> Sensors and Switches - Restraints and Safety Systems >> Impact Sensor >> Service and Repair >> Front Impact Sensor Replacement

Front Impact Sensor Replacement

Front Impact Sensor Replacement

Removal

1. Disconnect the negative cable from the battery, then wait for 3 minutes before starting work.
2. Disconnect the driver's airbag 4P connector, the front passenger's airbag 4P connector, both seat belt tensioner 4P connectors, and both seat belt buckle tensioner 4P connectors.
3. Remove the front bumper.
4. Disconnect the engine compartment wire harness 2P connector (A) from the front impact sensor. Using a TORX T30 bit, remove the TORX bolts (B), then remove the front impact sensor (C). Replace the bolts.






Installation

1. Install the new front impact sensor with new TORX bolts (A), then connect the engine compartment wire harness 2P connector (B) to the front impact sensor (C).






2. Reconnect the negative cable to the battery.
3. After installing the front impact sensor, confirm proper system operation: Turn the ignition switch ON (II); the SRS indicator should come on for about 6 seconds and then go off.
4. Reinstall all removed parts.
pro multis · About Operation CHARM