Transfer Assembly Installation

Transfer Assembly Installation

1. Clean the areas where the transfer assembly contacts the transmission with solvent, and dry with compressed air. Then apply transmission fluid to the contact area.
2. Install the dowel pin (A) in the transmission, and install the transfer assembly (B) on the transmission.





3. Install the propeller shaft (A) to the transfer companion flange (B) by aligning the reference mark (C).





4. Secure the transfer breather hose bracket (A) on the transfer assembly with the bolt, and install the breather hose (B) over the breather pipe (C) with the dot (D) facing toward the rear.





5. Install the three-way catalytic converter (A) with the new self-locking nuts and new gaskets (B) (C).





6. Refill the transfer assembly with transfer fluid (hypoid gear oil), if necessary.
7. Refill the transmission with ATF.