Driver's Power Window Motor Test
Driver's Power Window Motor TestMotor Test
1. Remove the power window master switch, and disconnect the connectors.
2. Test the motor in each direction by connecting battery power and ground to the power window master switch 22P connector according to the table.
3. If the motor does not run or fails to run smoothly, go to step 4.
4. Disconnect the 6P connector from the driver's power window motor.
5. Check for continuity between the power window master switch 22P connector No. 20 and No. 21 terminals and the driver's power window motor 6P connector No. 1 and No. 4 terminals, respectively.
6. If the wire harness is OK, replace the driver's power window motor.
Pulser Test
7. Do the power window master switch input test No. 5, No. 6, No. 7, and No. 11 terminals.