Wiper Motor Replacement
Wiper Motor ReplacementRemoval
1. Open the hood. Remove the caps, nuts (A), and the windshield wiper arms (B).
2. Remove the cowl covers.
3. Disconnect the 5P connector (A) from the wiper motor.
4. Remove the two bolts and the bracket (B).
5. Remove the four bolts (C) and the wiper linkage assembly (D).
6. Remove the nut (A) and the link (B) from the wiper motor (C).
7. Remove the three bolts (D), and the wiper motor from the wiper linkage assembly (E).
Installation
1. Before installing the motor, plug it in, then turn the wiper/washer switch to (LO) or (HI) ON, then OFF to return the motor shaft to the park position.
NOTE:
- Does not use the wiper/washer switch (INT) position in this step.
- If necessary, replace any damaged clips.
- Apply multipurpose grease to the moving parts.
2. Install the wiper motor to the wiper linkage assembly.
3. Install the link to the wiper motor shaft, then align the mark (A) of the link and the mark (B) of the wiper linkage assembly.
4. Before installing the wiper linkage assembly to the vehicle, align the mark (A) of the link and the mark (B) of the linkage assembly.
5. After installation, adjust the wiper arms.