DTC Troubleshooting

DTC Troubleshooting: P2238

DTC P2238: A/F Sensor (Sensor 1) AFS+ Circuit Low Voltage

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. Initial Inspection and Diagnostic Overview

1. Turn the ignition switch to ON (II).

2. Clear the DTC with the HDS.

3. Check for Temporary DTCs or DTCs with the HDS.

Is DTC P2238 indicated?
YES - Go to step 4.

NO - Intermittent failure, the system is OK at this time. Check for poor connections or loose terminals at the A/F sensor (Sensor 1) and the PCM.


4. Turn the ignition switch to LOCK (0).

5. Jump the SCS line with the HDS.

6. Disconnect the A/F sensor (Sensor 1) 4P connector.

7. Disconnect PCM connector C (44P).

8. Check for continuity between PCM connector terminal C29 and body ground.

Is there continuity?
YES - Repair short in the wire between the PCM (C29) and the A/F sensor (Sensor 1), then go to step 10.

NO - Go to step 9.






9. Replace the A/F sensor (Sensor 1). A/F Sensor Replacement

10. Reconnect all connectors.

11. Turn the ignition switch to ON (II).

12. Reset the PCM with the HDS.

13. Do the PCM idle learn procedure. PCM Idle Learn Procedure

14. Check for Temporary DTCs or DTCs with the HDS.

Is DTC P2238 indicated?
YES - Check for poor connections or loose terminals at the A/F sensor (Sensor 1) and the PCM, then go to step 1. If the connector and terminal fits are OK, go to step 16.

NO - Go to step 15.


15. Monitor the OBD STATUS for DTC P2238 in the DTCs MENU with the HDS.

Does the screen indicate PASSED?
YES - Troubleshooting is complete. If any other Temporary DTCs or DTCs were indicated in step 14, go to the indicated DTC's troubleshooting.

NO - If the screen indicates FAILED, check for poor connections or loose terminals at the A/F sensor (Sensor 1) and the PCM, then go to step 1. If the screen indicates NOT COMPLETED, keep idling until a result come on.


16. Update the PCM if it does not have the latest software, PCM Update or substitute a known-good PCM. Initial Inspection and Diagnostic Overview

17. Start the engine, and let it idle.

18. Check for Temporary DTCs or DTCs with the HDS.

Is DTC P2238 indicated?
YES - If the PCM was updated, substitute a known-good PCM, Initial Inspection and Diagnostic Overview then go to step 17. If the PCM was substituted, go to step 1.

NO - Go to step 19.


19. Monitor the OBD STATUS for DTC P2238 in the DTCs MENU with the HDS.

Does the screen indicate PASSED?
YES - If the PCM was updated, troubleshooting is complete. If the PCM was substituted, replace the original PCM. Service and Repair If any other Temporary DTCs or DTCs were indicated in step 18, go to the indicated DTC's troubleshooting.

NO - If the screen indicates FAILED, go to step 1. If the PCM was updated, substitute a known-good PCM, Initial Inspection and Diagnostic Overview then go to step 17. If the PCM was substituted, go to step 1. If the screen indicates NOT COMPLETED, keep idling idle until a result comes on.