Power Mirror Control Unit Input Test

Power Mirror Control Unit Input Test

1. Remove the driver's dashboard undercover. Driver's Dashboard Undercover Removal/Installation

2. Disconnect the 24P connector (A) from the power mirror control unit (B).

3. Inspect the connector and socket terminals to be sure they are all making good contact.
- If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system.

- If the terminals look OK, go to step 4.

4. Reconnect the 24P connector to the control unit, and do these input tests at the following connector.
- If any test indicates a problem, find and correct the cause, then recheck the system.

- If all the input tests prove OK, go to step 5.





*1: '07 model

*2: '08-09 models









*1: '07 model

*2: '08-09 models

5. Check the PCM DTCs. If there is no DTC, jump the SCS line with the HDS, then disconnect PCM connector A (44P) ('07 model), the power seat control unit 40P connector ('08 model), and the power mirror control unit 24P connector.

6. Make these input tests at the following connector.
- If any test indicates a problem, find and correct the cause, then recheck the system.

- If all the input tests prove OK, the control unit must be faulty; replace the power mirror control unit.





*: '08-09 models





*1: '07 model

*2: '08-09 models





*: '08-09 models