Programming and Relearning

Moonroof Control Unit Reset

NOTE:

- Perform resetting the moonroof control unit with all the doors and tailgate closed.

- The clear procedure must be done first.

Resetting the moonroof is required when any of the following has occurred:

- The moonroof was moved manually while the battery was dead or disconnected.

- The moonroof motor was replaced with a new one.

- Any of components related to the moonroof were replaced.
- Wind deflector

- Moonroof glass

- Moonroof seal

- Moonroof glass bracket

- Moonroof cables, etc.

To reset the moonroof control unit, do these steps:

1. Close the doors.

2. Turn the ignition switch to LOCK (0).

3. Press in and hold the tilt switch, and turn the ignition switch to ON (II).

4. Release the tilt switch, and turn the ignition switch to LOCK (0).

5. Repeat step 2 and 3 four times.

6. Confirm the auto open/close function does not work. If the auto open/close function does work, repeat the clear procedure.

7. Press and hold the moonroof open switch for 3 additional seconds after the moonroof is fully opened.

8. Press and hold the moonroof close switch for 3 additional seconds after the moonroof is fully closed (tilted).

9. Confirm that the moonroof control unit is reset by using the moonroof AUTO OPEN and AUTO CLOSE function.