Under-Hood Fuse/Relay Box Removal and Installation

Under-hood Fuse/Relay Box Removal and Installation

Special Tools Required

- Relay puller 07AAC-000A1A0

Removal

1. Make sure you have the anti-theft codes for the audio system and the navigation system (if equipped).

2. Make sure the ignition switch is in LOCK (0).

3. Do the battery terminal disconnection procedure. Procedures

4. Remove the screws (A) for the alternator and battery cable terminals from the under-hood fuse/relay box.

5. Release the tab (B), and then remove the bottom cover (C) from the under-hood fuse/relay box.

6. Disconnect the connectors from the under-hood fuse/relay box.

7. Carefully remove the relays by using the relay puller.
NOTE: Do not use pliers. Pliers will damage the relays, which could cause the engine to stall or not start.






Installation

1. Install the relays and connect the connectors to the under-hood fuse/relay box, then install the under-hood fuse/relay box in the reverse order of removal.

2. Install the removed parts in the reverse order of removal.

3. Do the battery terminal reconnection procedure. Procedures

4. Enter the anti-theft codes for the audio system and the navigation system (if equipped). Set the clock (on vehicles without navigation).

5. Confirm that all systems work properly.