Seat Position Sensor: Service and Repair

Driver's Seat Position Sensor Replacement

Removal

NOTE:

- Removal of the driver's seat position sensor must be performed according to the precautions/procedures described at the beginning of SRS section. Service and Repair

- Do not turn the ignition switch to ON (II), and do not connect the battery cable while removing the driver's seat position sensor.

1. Do the battery terminal disconnection procedure Procedures, then wait for 3 minutes before starting work.

2. Remove the driver's seat assembly: '09 model. Front Seat Removal/Installation

3. Disconnect the driver's seat wire harness or seat position sensor harness 2P connector (A) from the driver's seat position sensor.

4. Using a mounting nut (B), then remove the driver's seat position sensor.






Installation

NOTE:

- Be sure to install the harness so it is not pinched or interfere with other parts.

- Do not turn the ignition switch to ON (II), and do not connect the battery cable while installing the driver's seat position sensor.

- After installing the driver's seat position sensor, make sure it is clean. Keep it away from dust.

1. Install the new driver's seat position sensor with a mounting nut (A), then connect the driver's seat wire harness or seat position sensor harness 2P connector to the driver's seat position sensor (B).

2. Install the driver's seat assembly: '09 model. Front Seat Removal/Installation

3. Do the battery terminal reconnection procedure. Procedures

4. Check the operation of the driver's seat position sensor with the HDS. Driver's Seat Position Sensor Operation Check