Operation CHARM: Car repair manuals for everyone.

Side Impact Sensor (Second) Replacement




Side Impact Sensor (Second) Replacement

Removal

1. Do the battery terminal disconnection procedure Procedures, then wait for 3 minutes before starting work.

2. Remove the rear seat and seat side bolster. Rear Seat Removal/Installation

3. Disconnect the SRS wire harness 2P connector from the side impact sensor (second).

4. Remove the TORX bolt (A) using a TORX T30 bit, then remove the side impact sensor (second) (B).






Installation

1. Install the new side impact sensor (second) with the TORX bolt (A), then connect SRS wire harness 2P connector (B) to the side impact sensor (second).

2. Do the battery terminal reconnection procedure. Procedures

3. After installing the side impact sensor (second), confirm proper system operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about 6 seconds and then go off.

4. Reinstall all removed parts.