Removal and Replacement

Battery Removal and Installation

NOTE: The battery terminal disconnection/reconnection procedure Procedures must be done before and after doing this procedure. Some systems store data in memory that is lost when the battery is disconnected.

Removal

1. Do the battery terminal disconnection procedure. Procedures

2. Remove the two nuts (A) securing the battery setting plate, then remove the battery setting plate (B) and the battery (C).






Installation

1. Install the battery (A), then install the battery setting plate (B).

2. Tighten the two nuts (C) equally until the battery is stable.
NOTE: Do not deform the battery setting plate by tightening the nuts too much.

3. Do the battery terminal reconnection procedure. Procedures
NOTE: Make sure the positive terminal and the negative terminal are not reverse-connected.