Intermediary Shaft 3rd Gear Axial Clearance Inspection

Intermediary Shaft 3rd Gear Axial Clearance Inspection

Special Tools Required

- Driver, 40 mm I.D. 07746-0030100
1. Install the 3rd clutch (A), the original thickness 53 mm splined washer (B), the thrust needle bearing (C), the needle bearing (D), the 3rd gear (E), and the thrust needle bearing (F) on the intermediary shaft (G). Do not install the O-rings during inspection.

2. Install 4th gear (H) using the driver (40 mm I.D.) and a press.

3. Install the cotters (I), the cotter retainer (J), and the snap ring (K).











4. Set the dial indicator (A) on 3rd gear (B).






5. Measure 3rd gear axial clearance in at least three places while moving 3rd gear. Use the average as the actual clearance.

Standard: 0.005-0.045 mm (0.0002-0.0018 in.)

6. If the clearance is out of the standard, remove the splined washer and measure its thickness.

7. Select and install a new splined washer, then recheck the clearance.

SPLINED WASHER, 53 mm