Torque Converter Housing Park Lever Shaft Bearing Replacement

Torque Converter Housing Park Lever Shaft Bearing Replacement

Special Tools Required

- Bearing remover shaft set, 12 mm 07936-1660101
- Sliding hammer weight 07741-0010201
- Driver 07749-0010000
- Attachment, 22 x 24 mm 07746-0010800
1. Remove the park lever shaft bearing from the torque converter housing using the bearing remover shaft set (12 mm) and the sliding hammer weight.






2. Install the new bearing until it bottoms in the housing using the drive and the attachment (22 x 24 mm).