With Navigation System
DTC Troubleshooting: B1776
DTC B1776:
Microphone Input/Output Shorted to Ground or Open (with navigation system)
NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A Troubleshooting - B-CAN System Diagnosis Test Mode A.
1. Connect the HDS to the DLC Initial Inspection and Diagnostic Overview.
2. Clear the DTCs with the HDS.
3. Turn the ignition switch to LOCK (0) and then back to ON (II).
4. Check for DTCs with the HDS.
Is DTC B1776 indicated?
YES -
Go to step 5.
NO -
Intermittent failure, the system is OK at this time.�
5. Turn the ignition switch to LOCK (0).
6. Disconnect the HFL-navigation microphone (roof console) 20P connector and the HandsFreeLink control unit 28P connector.
7. Check for continuity between body ground and HandsFreeLink control unit 28P connector terminals No. 13 and No. 14 individually, then between terminals No. 12 and No. 13.
Is there continuity?
YES -
There is a short in the wire(s) between the HandsFreeLink control unit and the HFL-navigation microphone (roof console). Replace the affected shielded harness.�
NO -
Go to step 8.
8. Check for continuity between HandsFreeLink control unit 28P connector terminals No. 13 and No. 14 and HFL-navigation microphone (roof console) 20P connector terminals No. 8 and No. 10 respectively.
Is there continuity?
YES -
Go to step 9.
NO -
There is an open in the wire(s) between the HandsFreeLink control unit and the HFL-navigation microphone (roof console). Replace the affected shielded harness.�
9. Disconnect navigation unit connector C (16P).
10. Check for continuity between body ground and HandsFreeLink control unit 28P connector terminals No. 27 and No. 28 individually.
Is there continuity?
YES -
There is a short to body ground in the wire(s) between the HandsFreeLink control unit and the navigation unit. Replace the affected shielded harness.�
NO -
Go to step 11.
11. Check for continuity between HandsFreeLink control unit 28P connector terminals No. 27 and No. 28 and navigation unit connector C (16P) terminals No. 8 and No. 16 respectively.
Is there continuity?
YES -
Substitute a known-good HandsFreeLink control unit Service and Repair, and recheck. If the symptom goes away, replace the original HandsFreeLink control unit Service and Repair. If the symptom does not go away, replace the navigation unit Service and Repair.�
NO -
There is an open in the wire(s) between the HandsFreeLink control unit and the navigation unit. Replace the affected shielded harness.�