DTC Troubleshooting

DTC Troubleshooting: P0420

DTC P0420:

Catalyst System Efficiency Below Threshold

NOTE:

- Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information Initial Inspection and Diagnostic Overview.
- Poor quality fuel may cause this DTC.

1. Turn the ignition switch to ON (II).

2. Clear the DTC with the HDS.

3. Start the engine. Hold the engine speed at 3,000 rpm without load (in P or N) until the radiator fan comes on, then let it idle.

4. Test-drive under these conditions:

- Engine coolant temperature (ECT SENSOR 1) above 158 °F (70 °C)
- Transmission in D
- Vehicle speed between 45-75 mph (72-120 km/h) for 5 minutes or more with cruise control set
- Maintain the vehicle speed at 55 mph (88 km/h) for 5 minutes or more with cruise control set

5. Monitor the OBD STATUS for DTC P0420 in the DTCs MENU with the HDS.

Does the screen indicate EXECUTING?

YES -

Go to step 6.

NO -

If the screen indicates OUT OF CONDITION, go to step 4 and recheck. If the screen indicates PASSED, intermittent failure, the system is OK at this time. If the screen indicates FAILED, go to step 8.

6. Continue test driving until a result comes on.

7. Monitor the OBD STATUS for DTC P0420 in the DTCs MENU with the HDS.

Does the screen indicate FAILED?

YES -

Go to step 8.

NO -

If the screen indicates PASSED, intermittent failure, the system is OK at this time. If the screen indicates EXECUTING, keep driving until a result comes on. If the screen indicates OUT OF CONDITION, go to step 4 and recheck.

8. Turn the ignition switch to LOCK (0).

9. Replace the WU-TWC Warm Up TWC Removal/Installation.

10. Turn the ignition switch to ON (II).

11. Reset the PCM with the HDS.

12. Do the PCM idle learn procedure PCM Idle Learn Procedure.

13. Start the engine. Hold the engine speed at 3,000 rpm without load (in P or N) until the radiator fan comes on, then let it idle.

14. Test-drive for about 10 minutes, varying the vehicle speed.

15. Check the CATA MONITOR CONDITION in the DATA LIST with the HDS.

Is the temperature OK?

YES -

Go to step 16.

NO -

Go to step 13 and recheck.

16. Test-drive under these conditions:

- Engine coolant temperature (ECT SENSOR 1) above 158 °F (70 °C)
- Transmission in D
- Vehicle speed at 55 mph (88 km/h) for 5 minutes or more with cruise control set

17. Monitor the OBD STATUS for DTC P0420 in the DTCs MENU with the HDS.

Does the screen indicate EXECUTING?

YES -

Go to step 18.

NO -

Go to step 16 and recheck.

18. Continue test-driving until a result comes on.

19. Check for Pending or Confirmed DTCs with the HDS.

Are any Pending or Confirmed DTCs indicated?

YES -

Go to the indicated DTC's troubleshooting.�

NO -

Go to step 20.

20. Monitor the OBD STATUS for DTC P0420 in the DTCs MENU with the HDS.

Does the screen indicate PASSED?

YES -

Troubleshooting is complete.�

NO -

If the screen indicates FAILED, check the fuel quality. If the screen indicates EXECUTING, keep driving until a result comes on. If the screen indicates OUT OF CONDITION, go to step 13.