Side Impact Sensor (First) Replacement

Side Impact Sensor (First) Replacement

Removal

1. Do the battery terminal disconnection procedure Procedures, then wait for 3 minutes before starting work.

2. Remove the front seat Front Seat Removal/Installation.

3. Remove the B-pillar lower trim Interior Trim Removal/Installation - Pillar Areas.

4. Disconnect the SRS wire harness 4P connector (A) from the side impact sensor (first).





5. Remove the TORX bolt (B) using a TORX T30 bit, then remove the side impact sensor (first) (C).

Installation

1. Install the side impact sensor (first) (A) with a new TORX bolt (B) using a TORX T30 bit, then connect the SRS wire harness 4P connector (C) to the side impact sensor (first).





2. Do the battery terminal reconnection procedure Procedures.

3. Clear any DTCs with the HDS Reading and Clearing Diagnostic Trouble Codes.

4. Confirm proper SRS operation: Turn the ignition switch to ON (II), and check that the SRS indicator comes on for about 6 seconds and then go off.

5. Reinstall all removed parts.