Transmission Range Switch Test

Transmission Range Switch Test

1. Do the battery removal procedure Removal and Replacement.

2. Remove the battery base Engine Removal.

3. Disconnect the transmission range switch connector.






4. Check for continuity between terminals at the transmission range switch connector. There should be continuity between the terminals in the following table for each switch position.





5. Transmission range switch test is finished if the test results are OK. If there is no continuity between any terminals, check that the transmission range switch installation. If the switch installation is OK, replace the transmission range switch Service and Repair.

6. Check the connector for rust, dirt, or oil, and clean or repair if necessary, then connect the connector securely.

7. Install the battery base Engine Installation.

8. Do the battery installation procedure Removal and Replacement.