Operation CHARM: Car repair manuals for everyone.

Front Seat Frame Replacement - Passenger's Seat




Front Seat Frame Replacement - Passenger's Seat

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*Available through the Acura Tool and Equipment Program; 888-424-6857

Passenger's Seat

SRS components are located in this area. Review the SRS component locations Locations and the precautions and procedures Service and Repair before doing repairs or service.

NOTE:

- Put on gloves to protect your hands.
- Take care not to tear or damage the seat covers.
- Use the appropriate tool from KTC trim tool set to avoid damage when removing components.
- If the side airbag has deployed, replace the seat frame and related parts with new ones Service and Repair.
- Do the ODS unit initialization after front passenger's seat replacement Programming and Relearning.

1. Remove the front seat Front Seat Removal/Installation.

2. Remove these items:

- Front seat-back cover/pad Front Seat-back Cover/Pad Replacement
- Front seat cushion cover/pad Front Seat Cushion Cover/Pad Replacement
- Seat belt buckle Front Seat Belt Replacement
- Side airbag Side Airbag Replacement
- ODS unit ODS Unit Replacement

3. Remove the recline inner cover (A) and the center inner cover (B) from the seat frame (C).






Slide motor removal

4. Remove the flex cable (A) and the cable housing (B).

1. Release the housing from the hooks (C).

2. Disconnect the cable from the worm gear (D) in the inner seat track by pulling out the housing.

3. Disconnect the cable from the slide motor (E).

NOTE: Take care not to kink the cable.





5. Disconnect the slide motor connector (A), and detach the harness clip (B). Remove the bolts securing the slide motor bracket (C) using a TORX T30 bit.






6. Remove the slide motor bracket (A) from the slide gearbox bracket by pulling out the inner side of the slide motor bracket, and disconnect the slide motor (B) from the short flex cable (C) by pulling out the bracket.






7. Pull out the short flex cable (A) from the worm gear (B) in the outer seat track.






8. Remove the screws, then remove the slide motor (A) from the slide motor bracket (B).

NOTE:

- Apply multipurpose grease to the worm gear portions in both seat tracks.
- Install the short flex cable to the slide motor, before installing the slide motor to the slide motor bracket.
- Make sure the short flex cable and the flex cable are connected properly.





9. Install the new seat frame in the reverse order of removal, and note these items:

- If the clips are damaged or stress-whitened, replace them with new ones.
- Push the clips into place securely.
- Make sure the connector is plugged in properly.
- Check the front seat slide, recline operation.
- To prevent wrinkles when installing a seat-back cover, make sure the material is stretched evenly over the pad before securing the hook strips.