Engine Oil Pan Removal

Engine Oil Pan Removal

Special Tools Required

- Subframe Adapter VSB02C000016
*Available through the Acura Tool and Equipment Program 888-424-6857

1. If the engine already is out of the vehicle, go to step 14.

2. Raise the vehicle on the lift to full height.

3. Drain the engine oil Service and Repair.

4. Remove the front wheels.

5. Remove the splash shield Front Splash Shield Replacement.

6. Remove the bolt securing the P/S fluid line bracket and unclamp the P/S fluid line clamps on the front subframe Engine Removal.

7. Remove the bolts securing the steering gearbox mounting brackets Engine Removal.

8. Remove the two bolts at the under-floor three way catalytic converter (TWC) front joint Under-Floor TWC Removal/Installation.






9. Remove the lower torque rod Engine Removal.

10. Attach the subframe adapter (A) to the subframe and hang the belt of the subframe adapter over the front of the subframe, then secure the belt with its stop.






11. Raise the jack and line up the slots in the arms with the bolt holes on the corner of the jack base, then attach them with bolts securely.

12. Remove the 12 x 1.25 mm bolts (A), then loosen the 14 x 1.5 mm bolts (B) on the subframe so they are about 30 mm (1.2 in) from the mounting surface.






13. Remove the subframe adapter.

14. Remove the lower torque rod bracket.






15. Remove the torque converter cover (A) and the transmission mounting bolts (B).






16. Remove the bolts securing the oil pan.

17. Insert a flat blade screwdriver, and separate the oil pan from the block in the places shown.






18. Remove the oil pan.