Front Stabilizer Bar Replacement

Front Stabilizer Bar Replacement

1. Raise and support the vehicle Service and Repair.

2. Remove the front wheels.

3. Disconnect both tie-rod end ball joints from the knuckle Front Knuckle/Hub/Wheel Bearing Replacement.

4. Disconnect both stabilizer links from the stabilizer bar Front Stabilizer Link Removal/Installation.

5. Remove the flange bolts (A) and the bushing holders (B), then remove the bushings (C).

NOTE: During installation, align the paint marks (D) on the stabilizer bar with the sides of the bushings.





6. Remove the stabilizer bar (E) through the wheelwell opening on the passenger's side.

7. Install the stabilizer bar in the reverse order of removal, and note these items:

- Note the right and left direction of the stabilizer bar.
- Align the paint marks on the stabilizer bar with the sides of the bushings.
- Note the fore/aft direction of the bushing.
- Refer to stabilizer link removal/installation to connect the stabilizer bar to the links Front Stabilizer Link Removal/Installation.
- Before installing the wheel, clean the mating surface of the brake disc and the inside of the wheel, then install the front wheels.
- Check the wheel alignment, and adjust it if necessary Service and Repair.