A/T Differential Carrier Bearing Outer Race Replacement

A/T Differential Carrier Bearing Outer Race Replacement

Special Tools Required

- Driver Handle, 15 x 135L 07749-0010000
- Attachment, 83 mm 07HAD-SG00100
- Attachment, 78 x 90 mm 07GAD-SD40101

NOTE:

- Replace the tapered roller bearing with a new one whenever the outer race is replaced.
- Do not use shim(s) on the torque converter housing side.
- Adjust the preload after replacing the bearing and the outer race.
- Coat all parts with ATF during installation.
- The illustration shows the with SH-AWD; the without SH-AWD is similar.

1. Remove the bearing outer race (A), the spacer (B), and the 85 mm thrust shim (C) from the transmission housing (D) by heating the housing to about 212 °F (100 °C) using a heat gun (E). Do not heat the housing more than 212 °F (100 °C).

NOTE: Let the transmission housing cool to room temperature before installing a new bearing outer race.






2. Install the 85 mm thrust shim (A), the spacer (B), and a new outer race (C) in the transmission housing (D).






3. Drive the bearing outer race securely in the transmission housing using the driver handle (15 x 135L) and attachment (83 mm) so there is no clearance between the bearing outer race, the spacer, the 85 mm thrust shim, and the transmission housing.






4. Remove the plate (A), and remove the bearing outer race (B) and the spacer (C) from the torque converter housing (D).





5. Install the spacer and a new bearing outer race in the torque converter housing.

6. Drive the bearing outer race securely in the torque converter housing using the driver handle (15 x 135L) and the attachment (78 x 90 mm).





7. Install the plate over the bearing outer race in the torque converter housing.