A/T Differential Carrier Bearing Replacement

A/T Differential Carrier Bearing Replacement

Special Tools Required

- Installer Attachment, 45 x 55 mm 07MAD-PR90100

NOTE:

- The bearing and outer race should be replaced as a set.
- Inspect and adjust the carrier bearing preload whenever the bearing is replaced.
- Check the bearing for wear and rough rotation. If the bearing is OK, removal is not necessary.
- The illustration shows the with SH-AWD; the without SH-AWD is similar.

1. Remove the carrier bearing (A) with a commercially available bearing puller (B), a bearing separator (C), and a spacer (D).






2. Install new carrier bearings using the installer attachment (45 x 55 mm) and a press.

NOTE:

- Press the bearing on until it bottoms.
- Use the small end of the installer attachment (45 x 55 mm) to install the bearings.
- Press the bearing on securely so there is no clearance between the bearing and the differential carrier.