A/T Intermediary Shaft 3rd Gear Axial Clearance Inspection

A/T Intermediary Shaft 3rd Gear Axial Clearance Inspection

Special Tools Required

- Driver Handle, 40 mm I.D. 07746-0030100

1. Install the 3rd clutch (A), the original thickness 53 mm splined washer (B), the 30 x 52 x 3 mm thrust needle bearing (C), the needle bearing (D), the intermediary shaft 3rd gear (E), and the 30 x 52 x 3 mm thrust needle bearing (F) on the intermediary shaft (G). Do not install the O-rings during inspection.










2. Install the intermediary shaft 4th gear (H) using the driver handle (40 mm I.D.) and a press.

3. Install the cotters (I), the cotter retainer (J), and the snap ring (K).

4. Set a dial indicator (A) on the intermediary shaft 3rd gear (B).






5. Measure the intermediary shaft 3rd gear axial clearance in at least three places while moving the intermediary shaft 3rd gear. Use the average as the actual clearance.









6. If the clearance is out of the standard, remove the 53 mm splined washer and measure its thickness.

7. Select and install a new 53 mm splined washer, then recheck the clearance.

SPLINED WASHER, 53 mm