B1376

DTC Troubleshooting: B1376

DTC B1376:

Tailgate Outer Handle Switch Circuit Malfunction

NOTE: If the power tailgate motor does not operate, do the motor test first.

1. Turn the ignition switch to LOCK (0) and then back to ON (II).

2. Clear the DTCs with the HDS, and wait for 2 seconds.

3. Pull the tailgate outer handle for at least 2 seconds.

4. Check for DTCs with the HDS.

Is DTC B1376 indicated?

YES -

Go to step 5.

NO -

Intermittent failure, the system is OK at this time. Check for loose or poor connections between the power tailgate control unit and the tailgate outer handle switch.�

5. Turn the ignition switch to LOCK (0).

6. Open the power tailgate with the keyless transmitter.

7. Disconnect the 3P connector from the tailgate outer handle switch.

8. Disconnect power tailgate control unit connector C (14P).

9. Check for continuity between power tailgate control unit connector C (14P) terminal No. 9 and body ground.





Is there continuity?

YES -

Repair a short in the wire.�

NO -

Go to step 10.

10. Disconnect power tailgate control unit connector B (20P).

11. Check for continuity between power tailgate control unit connector B (20P) terminal No. 5 and body ground.





Is there continuity?

YES -

Repair a short in the wire.�

NO -

Go to step 12.

12. Do the tailgate outer handle switch test Tailgate Outer Handle Switch Test/Replacement.

Is the switch OK?

YES -

Replace the power tailgate control unit.�

NO -

Replace the tailgate outer handle switch.�