VSA System

VSA DTC Troubleshooting: 61

DTC 61:

Battery Voltage Low

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information.

1. Turn the ignition switch to ON (II).

2. Clear the DTC with the HDS.

3. Test-drive the vehicle at 2 mph (3 km/h) or more.

4. Check for DTCs with the HDS.

Is DTC 61 indicated?

YES -

Go to step 5.

NO -

Intermittent failure, the system is OK at this time. Check for loose terminals at the VSA modulator-control unit 46P connector. Check for a loose connection at G303. Refer to intermittent failures troubleshooting.�

5. Test the battery Battery Test, and connections Procedures.

Are the battery and battery connections OK?

YES -

Check for a poor connection at all IG1 circuit connections between the VSA modulator-control unit 46P connector terminal No. 40 and the under-dash fuse/relay box No. 29 (10A) fuse. If the connections are good, go to the Alternator and Regulator Circuit Troubleshooting Alternator and Regulator Circuit Troubleshooting.�

NO -

Replace or charge the battery Battery Test, or repair the connections.�